Waterfall Solution

The Australian bush is brutal, fire can come from any direction and you need to be ready for it. EmberAttack is one part of a larger solution to protect your home in a program of maintenance and prevention creating a waterfall from your gutters.

Creating Your Waterfall

Ember Attack Protection for your home

Creating Your Waterfall Effect

Flood Your Gutters and Create a Protective Waterfall Effect

It's a simple process to install your EmberAttack kit and this is why it's such a powerful defense during ember attack. During peak fire periods and when water supply is available, the cascading 'waterfall' around your home's perimeter provides maximum protection. The Watergate valve blocks your downpipes in seconds, flooding your gutters until they overflow. This creates a continuous water curtain that extinguishes embers before they can ignite your eaves, one of the most vulnerable points bushfires typically take hold. Use this mode whenever you have access to water supply for the most comprehensive ember protection.

Installation

To install EmberAttack cut a 100mm section into your down pipe to install EmberAttack with the Watergate valve at a manageable height approximately 1200mm off the ground.

Please note please positioning the connectors above the Watergate Valve

Once EmberAttack is installed into the downpipes make sure all joins are water proof using suitable pipe adhesives and silicone adhesives.

To create the Waterfall effect which back fills your gutters:-

  1. Remove one of the caps and install a snap on hose connector.
  2. Plug on the hose to the just installed connector.
  3. Insert the Watergate valve, pushing right into the slide and across the pipe cutting the water or stopping it from flowing through the pipe.
  4. Turn the tap on and allow the water to flow up the gutters to fill them. Once full the gutters will overflow creating a waterfall effect wetting the area around your home protecting the gutters and the area around your home from embers. At this point you can choose to leave the tap on or switch off to conserve water.

PDF Download

More EmberAttack Video guides

Frequently Asked Questions

If my roof has 2 or more gutters how many EmberAttack do I need?

Your house roof is broken into segments. If your house is an A-Frame style house you will have a gutter on each side of the “A”. Th Gutter on one side may have 2 down pipes and on the other 1 = therefore you will need 3 but only use 2. You will use 2 EmberAttack systems on each side. The side that has 2 downpipes we will block off when needed but we will only run the Waterfall or Sprinkler System on a down pipe on each side otherwise we will get uneven flow which will cause problems.

Which is the best system Waterfall or Sprinkler?

Both systems are good and protect your eves from EmberAttack which is where 90 percent of house fires start. The Sprinkler System is more expensive to set up but provides better whole roof coverage including solar panels.

EmberAttack Sprinkler System

EmberAttack Sprinkler System uses easy to install PVC 19-20mm hose and sprinkler spray heads connected to a high pressure 12v water pump connected to a 12v battery.

Can Ember Attack be used as a First Flush?

Yes EmberAttack can be used as a First Flush where the Watergate Valve is left in place for the first 5 minutes of rain with the side drain plugs removed allowing the dirty roof water to drain away before the Watergate Valve is removed for clean water to enter the tanks.

How does EmberAttack protect my tanks?

EmberAttack protects your tanks by blocking water from reaching your drinking water tanks using the patented Watergate Valve.

Is Ember Attack able to be used to clean my roof?

Yes EmberAttack is able to be used to protect my water tanks from soap and cleaning chemicals or just dirty dusty roof water. Major benefit for rural properties is the ability to clean you roof after a dust storm.

Up to 90% of homes lost in bushfires are destroyed by ember attack - not direct flames.
Ember attacks are lethal

Ready to protect your home?

It's not the fire that destroys most homes. It's the invisible ember attack that rains down kilometres ahead of the blaze. Up to 90% of homes lost in bushfires are destroyed by ember attack - not direct flames.

Contact Us Today

EmberAttack Enquiries

We'll get back to you ASAP

We're available 8:00 AM – 5:00 PM AEST



Please contact EmberAttack initially by form submission or email.
We will happily call you if preferred as we are located in the Northern Beaches Suburbs of Sydney, but if we can solve a problem by email it may be easier (but we recognise this is not always possible).
Patent No. 2010224350 | Patent Pending Application No. 2025902857
Feel free to contact us for more information
info@emberattack.com
© 2025 EmberAttack | All rights reserved
Terms & Conditions
Powered by ESB